| MRC |
Requirement Statement |
Characteristics |
| ABRE |
DISTANCE FROM CENTERLINE OF HOLE TO END OF PIN |
0.126 INCHES NOMINAL |
| AASY |
DISTANCE FROM CENTERLINE TO FLAT |
0.068 INCHES MINIMUM AND 0.088 INCHES MAXIMUM |
| CRTL |
CRITICALITY CODE JUSTIFICATION |
ABMZ |
| ABMZ |
DIAMETER |
0.155 INCHES MINIMUM AND 0.156 INCHES MAXIMUM |
| AAGZ |
FIRST END STYLE |
CHAMFERED |
| CRMG |
FIRST END TAPER ANGLE |
43.0 DEGREES MINIMUM AND 47.0 DEGREES MAXIMUM |
| AMCS |
FIRST END TAPER LENGTH |
0.010 INCHES MINIMUM AND 0.030 INCHES MAXIMUM |
| ABRC |
FIRST HOLE DIAMETER |
0.052 INCHES MINIMUM AND 0.056 INCHES MAXIMUM |
| AASK |
HEAD STYLE |
DEE |
| HGTH |
HEIGHT |
0.057 INCHES MINIMUM AND 0.067 INCHES MAXIMUM |
| ABRB |
HOLE ARRANGEMENT STYLE |
ONE END DRILLED |
| MDCL |
MATERIAL DOCUMENT AND CLASSIFICATION |
QQ-S-633,FS1015 THRU FS1045 FED SPEC SINGLE MATERIAL RESPONSE OVERALL |
| MATT |
MATERIAL |
STEEL OVERALL |
| CRRG |
PIN HEAD DIAMETER |
0.375 INCHES NOMINAL |
| ABPB |
UNDER HEAD LENGTH |
1.048 INCHES MINIMUM AND 1.078 INCHES MAXIMUM |
| ABPA |
UNDERCUT DIAMETER |
0.143 INCHES MINIMUM AND 0.153 INCHES MAXIMUM |
| ABPC |
UNDERCUT WIDTH |
0.030 INCHES MINIMUM AND 0.050 INCHES MAXIMUM |
| STYL |
STYLE DESIGNATOR |
GROOVE |
| CSYM |
SURFACE FINISH |
125.0 MICROINCHES HEAD BEARING SURFACE |
| CSYM |
SURFACE FINISH |
125.0 MICROINCHES HEAD OUTSIDE DIAMETER |
| CSYM |
SURFACE FINISH |
125.0 MICROINCHES HEAD TOP |
| CSYM |
SURFACE FINISH |
125.0 MICROINCHES CHAMFERED END |
| CSYM |
SURFACE FINISH |
32.0 MICROINCHES LONG SHANK |
| SFTT |
SURFACE TREATMENT |
OXIDE OVERALL |
