| MRC |
Requirement Statement |
Characteristics |
| AFEC |
DISTANCE FROM CENTER OF MOUNTING HOLE TO EDGE ALONG THE WIDTH |
0.250 INCHES NOMINAL |
| CWXN |
DISTANCE FROM END TO FIRST CLAMPING HOLE CENTER |
0.370 INCHES NOMINAL |
| CWXC |
DISTANCE FROM END TO FIRST MOUNTING HOLE CENTER |
0.810 INCHES NOMINAL |
| BYGG |
BLOCK HEIGHT |
0.380 INCHES NOMINAL |
| CWYM |
CENTER TO CENTER DISTANCE BETWEEN FIRST AND FIFTH CLAMPING HOLES |
2.750 INCHES NOMINAL |
| CWYH |
CENTER TO CENTER DISTANCE BETWEEN FIRST AND FOURTH CLAMPING HOLES |
1.880 INCHES NOMINAL |
| CWXZ |
CENTER TO CENTER DISTANCE BETWEEN FIRST AND SECOND CLAMPING HOLES |
0.820 INCHES NOMINAL |
| AXPC |
CENTER TO CENTER DISTANCE BETWEEN FIRST AND SECOND MOUNTING HOLES |
1.870 INCHES NOMINAL |
| CWYC |
CENTER TO CENTER DISTANCE BETWEEN FIRST AND THIRD CLAMPING HOLES |
1.380 INCHES NOMINAL |
| CWWM |
CLAMPING HOLE DIAMETER |
0.249 INCHES MINIMUM FIRST HOLE AND 0.255 INCHES MAXIMUM FIRST HOLE |
| CWWM |
CLAMPING HOLE DIAMETER |
0.374 INCHES MINIMUM ALL HOLES AND 0.381 INCHES MAXIMUM ALL HOLES |
| CWTD |
CLAMPING HOLE QUANTITY |
5 |
| MDCL |
MATERIAL DOCUMENT AND CLASSIFICATION |
MIL-P-15035 TY FBE MIL SPEC SINGLE MATERIAL RESPONSE |
| MATT |
MATERIAL |
PLASTIC AND COTTON |
| AZGM |
MOUNTING FACILITY |
UNTHREADED HOLE |
| ABTB |
MOUNTING HOLE DIAMETER |
0.193 INCHES MINIMUM AND 0.199 INCHES MAXIMUM |
| ABTJ |
MOUNTING HOLE QUANTITY |
2 |
| ABKW |
OVERALL HEIGHT |
0.760 INCHES NOMINAL |
| ABHP |
OVERALL LENGTH |
3.490 INCHES NOMINAL |
| ABMK |
OVERALL WIDTH |
0.500 INCHES NOMINAL |
| STYL |
STYLE DESIGNATOR |
RECTANGULAR |
