| MRC |
Requirement Statement |
Characteristics |
| AFEC |
DISTANCE FROM CENTER OF MOUNTING HOLE TO EDGE ALONG THE WIDTH |
0.188 INCHES NOMINAL |
| CWXN |
DISTANCE FROM END TO FIRST CLAMPING HOLE CENTER |
0.742 INCHES NOMINAL |
| CWXC |
DISTANCE FROM END TO FIRST MOUNTING HOLE CENTER |
0.250 INCHES NOMINAL |
| BYGG |
BLOCK HEIGHT |
0.375 INCHES NOMINAL |
| CWYH |
CENTER TO CENTER DISTANCE BETWEEN FIRST AND FOURTH CLAMPING HOLES |
2.508 INCHES NOMINAL |
| CWXZ |
CENTER TO CENTER DISTANCE BETWEEN FIRST AND SECOND CLAMPING HOLES |
0.728 INCHES NOMINAL |
| AXPC |
CENTER TO CENTER DISTANCE BETWEEN FIRST AND SECOND MOUNTING HOLES |
2.500 INCHES NOMINAL |
| CWYC |
CENTER TO CENTER DISTANCE BETWEEN FIRST AND THIRD CLAMPING HOLES |
1.514 INCHES NOMINAL |
| AXPE |
CENTER TO CENTER DISTANCE BETWEEN FIRST AND THIRD MOUNTING HOLES |
3.500 INCHES NOMINAL |
| CWWM |
CLAMPING HOLE DIAMETER |
0.500 INCHES MINIMUM ALL HOLES AND 0.504 INCHES MAXIMUM ALL HOLES |
| CWTD |
CLAMPING HOLE QUANTITY |
4 |
| MDCL |
MATERIAL DOCUMENT AND CLASSIFICATION |
MIL-P-15035,TYPE FBM MIL SPEC 2ND MATERIAL RESPONSE |
| MATT |
MATERIAL |
PLASTIC OR PLASTIC PHENOLIC |
| AZGM |
MOUNTING FACILITY |
UNTHREADED HOLE |
| ABTB |
MOUNTING HOLE DIAMETER |
0.190 INCHES MINIMUM AND 0.196 INCHES MAXIMUM |
| ABTJ |
MOUNTING HOLE QUANTITY |
3 |
| ABHP |
OVERALL LENGTH |
4.000 INCHES NOMINAL |
| ABMK |
OVERALL WIDTH |
0.380 INCHES NOMINAL |
| STYL |
STYLE DESIGNATOR |
RECTANGULAR |
