| MRC |
Requirement Statement |
Characteristics |
| AGAV |
END ITEM IDENTIFICATION |
OPERTING GEAR |
| AHPZ |
CENTER SECTION HEIGHT |
3.850 INCHES NOMINAL |
| AHQB |
CENTER SECTION THICKNESS |
0.125 INCHES NOMINAL |
| AHQA |
CENTER SECTION WIDTH |
0.620 INCHES NOMINAL |
| CSSQ |
FIRST LEG ANGLE |
175.0 DEGREES NOMINAL |
| AKAU |
FIRST LEG HOLE ARRANGEMENT STYLE |
ONE HOLE |
| AHLK |
FIRST LEG HOLE DIAMETER |
0.250 INCHES NOMINAL |
| AHRB |
FIRST LEG DISTANCE FROM EDGE TO HOLE CENTER ALONG LENGTH |
0.690 INCHES NOMINAL |
| AHRA |
FIRST LEG DISTANCE FROM EDGE TO HOLE CENTER ALONG WIDTH |
0.310 INCHES NOMINAL |
| AHPW |
FIRST LEG THICKNESS |
0.125 INCHES NOMINAL |
| AHQN |
FIRST LEG WIDTH |
0.620 INCHES NOMINAL |
| ADLK |
FIRST LEG LENGTH |
5.720 INCHES NOMINAL |
| AJZU |
FIRST LEG STYLE |
SQUARE |
| MDCL |
MATERIAL DOCUMENT AND CLASSIFICATION |
QQ-A-250/11 MIL SPEC SINGLE MATERIAL RESPONSE |
| MATT |
MATERIAL |
ALUMINUM ALLOY 6061 |
| ACHY |
MOUNTING HOLE TYPE |
PLAIN |
| AHLY |
SECOND LEG DISTANCE BETWEEN SECOND AND THIRD HOLE CENTERS ALONG LENGTH |
2.240 INCHES NOMINAL |
| AHLW |
SECOND LEG DISTANCE FROM EDGE TO HOLE CENTER ALONG LENGTH |
0.400 INCHES NOMINAL |
| AHLV |
SECOND LEG DISTANCE FROM EDGE TO HOLE CENTER ALONG WIDTH |
0.310 INCHES NOMINAL |
| CSSR |
SECOND LEG ANGLE |
110.0 DEGREES NOMINAL |
| AHLX |
SECOND LEG DISTANCE BETWEEN FIRST AND SECOND HOLE CENTERS ALONG LENGTH |
2.240 INCHES NOMINAL |
| ADLL |
SECOND LEG LENGTH |
1.940 INCHES NOMINAL |
| CSSP |
SECOND LEG RELATIONSHIP TO FIRST LEG |
NOT IDENTICAL |
| AKBU |
SECOND LEG STYLE |
SQUARE |
| AKCU |
SECOND LEG HOLE ARRANGEMENT STYLE |
THREE HOLES |
| AHLN |
SECOND LEG HOLE DIAMETER |
0.250 INCHES NOMINAL |
| AHPX |
SECOND LEG THICKNESS |
0.125 INCHES NOMINAL |
| AHLF |
SECOND LEG WIDTH |
0.620 INCHES NOMINAL |
| FEAT |
SPECIAL FEATURES |
BAREA BETWEEN LEGS HAS TWO MOUNTING HOLES SPACED 2.000 INCHES APART BEGINNING AT A POSITION 1.290 INCHES FROM 110 DEGREE ANGLE (OFF OF FIRST LEG) FOR USE ON GENERATOR EXHAUST LOUVER INSTALLATION |
| STYL |
STYLE DESIGNATOR |
ADJACENT ANGLES |
| STDC |
SURFACE TREATMENT DOCUMENT AND CLASSIFICATION |
DAMIL-A-8625TY2CL1 MIL SPEC 1ST TREATMENT RESPONSE AND MIL-P-23377 MIL SPEC 2ND TREATMENT RESPONSE AND MIL-C-22750 MIL SPEC 3RD TREATMENT RESPONSE |
| SFTT |
SURFACE TREATMENT |
ANODIZE AND PRIMER EPOXY AND PLASTIC EPOXY |
